Suminagashi is one of the oldest practices of marbleizing paper! This Japanese art form can be dated back to the 12th century and it’s name, “suminagashi”, means floating ink! Floating ink is exactly what we’ll be doing to create these fun pieces of paper!
What you’ll need:
Step one: Gather all your supplies. Fill your vat with approx. 1-2″ of water. In a small clean cup or dish, mix together a little dish soap and water (a drop of soap in 1/2 cup of water should do).
Step two: Dip one of your sumi brushes into your ink (try to just get ink on the brush bristles & avoid getting ink on the handle) and gently touch the surface of your water in your vat with the ink. You should be able to see the ink spread on the water’s surface! If it sinks to the bottom, try again, being careful not to break the waters surface with your brush. This also works best if your water is still – watch out for a lot of movement of a wobbly surface or a fan!
Step three: Grab another brush and dip this one into your soap mixture. Gently touch the surface of your water again, this time with the soapy mixture, placing your brush in the center of the ink bloom you made in the previous step! (Note: it can be hard to see the ink at first on the water’s surface, this is why I used blue ink, but don’t worry – your ink is still there!).
Step four: Continue going back and forth between your ink brush and your soapy mixture brush, repeating steps two & three, placing each alternating medium in the center of the last bloom you created. As you add more and more, it will continue to spread and fill your vat! If you’re having trouble getting your ink to float, sometimes this can mean we have too much soap in our water – try starting over with clean water and less soap in your soapy mixture!
Step five: If you have multiple colors of ink you can create your designs in the same steps above – just add in another brush with your additional color! This photo also shows a spot of ink that sank to the bottom of my vat – that blue spot we see on the left….any ink that ends up sinking, will not show on your paper, on the floating ink will become apart of your pattern!
Step six: You can also create multiple spots/centers on your surface by creating the pattern with your ink & soap mixture in various places – in this picture you can see four areas where I repeated the ink & soap mix pattern. You can also gently blow on the water’s surface to “move” your ink around on the surface. Even a little air movement will naturally do this to your ink on the surface, as well as the movement to the surface you’ll create when adding your ink and soap mixture! Be prepared to have your ink move around on the water surface slightly!
Step seven: Once you have your ink design on the surface of your water, gently place a piece of your paper on top – I find the best way to do this is to roll the paper slightly, having the center hit the water first and then carefully let the paper unroll onto the water.
Step eight: Let your paper sit in your water until the ink shows through slightly (like in the photo here or in step seven), this will only take around 30 seconds.
Step nine: Carefully lift your paper out of the water – the paper will be fragile as it’s wet, try to support it with your whole hand.
Step ten: Lay your wet paper on a flat protected work surface to dry. You may find that once dry, your paper is wrinkly – you can remedy this by placing a heavy stack of books on your paper for 24hrs (just make sure your paper is completely dry first!) or by ironing your paper flat – use a piece of parchment paper under and on top of your paper to protect from the iron.
Turn your papers into cards, gift tags, collages, bookmarks, stationary, origami, or for scrap booking projects!
Check out this method for other marbleized papers and this one to marbleize eggs! Be sure to let me know if you’ve given this a try!
